Description: This is a built-and-ready DIY backyard snowmaker. Made from 1/4 fittings with quick connect water and air fittings. Built with durable brass fittings, this component handles the mixing of air and water needed to create snow. Connect your own air compressor and pressure washer, and you’ll be ready to make snow in freezing temperatures. M22 x 14MM adapter included. Hand-built snowmaking gun made from brass fittings. Quality ball valve and quick connects already installed. Sealed and tested for leaks – works great when temps drop below freezing. What you’ll need to run it. A pressure washer (gas preferred, electric works but lighter snow). Cold temps (below 30°F wet bulb for best results). How it works: You connect your air line and water line, turn both on, and fine-mist snow starts spraying. Follow these steps to safely set up and operate your snow gun. Water Line: Connect your pressure washer hose to the quick-connect port near the yellow valve. Use the provided M22 x 14mm adapter if needed. Air Line: Connect your air hose to the quick-connect fitting at the bottom. Ensure the ball valve is CLOSED. Turn on the air compressor. Allow pressure to build up. Turn on the pressure washer. Slowly open the yellow ball valve to introduce water flow. Optimal Spray: Adjust the water valve to create a fine mist. The mist should atomize quickly upon leaving the nozzles. I’ll make sure the fittings and valve are protected. Compressor and pressure washer not included. Built strong – no plastic fittings. Pressure Washer Connection: Includes a female quick-connect fitting, plus an M22 x 14mm adapter for common pressure washer hoses. Air Connection: Has a male quick-connect fitting at the bottom for easy air hose hook-up. Complete Assembly: Ready to connect to your supply lines-no complex plumbing required. Fun backyard project that actually works. Turn your yard white even when Mother Nature won’t!